If working with your hands is something that you are good at, perhaps you should delve into the art of woodworking. Woodworking has been enjoyed for many years. It is still much appreciated and you can learn some tips by reading the following information.
Create sanding blocks you can reuse. Use a scrap of 3/4″ plywood to cut six blocks, one for each sandpaper grit you need. Make sure they are about 2.5″ x 4.75.” Put adhesive spray on the blocks and your cork tile square. Put one block on the cork, and then cut it flush with a knife. Spray adhesive on the back of your sandpaper sheets and attach to the cork blocks. Lastly, cut the sandpaper flush with the cork, and label each block.
Crosscut Guide
Use stair gauges as a crosscut guide. Clamp them to carpenter’s squares and be sure they match the runs and rises of the stair jacks. Then mark the notches. If you place the on the tongue that’s on your carpenter’s square, this means that together you can use this as a good crosscut guide for the circular saw.
Select the proper wood for any project you do. Some pieces require a durable hardwood, while others can be done with a softer type of wood. Learn about the types of wood you are using.
Gel Stains
Gel stains are a good way to stain furniture. Traditional liquid stains have a tendency to run. Gel stains grab on to the wood better. Gel stains also allow for consistent color on pieces since it is thicker.
A stair gauge is an essential item in every wood shop. They are typically used for laying out stair jacks, but they can also be used as a clamp for a carpenter’s square. This can make your carpenter’s square into a guide for your circular saw. Using the square can help you get straight cuts each time.
Rulers don’t like to stay in pockets, but you need them to be handy! A great way to remedy this problem is to purchase a metal ruler, keep this in your pocket with a telescoping magnet that is used to gather up any loose screws. The magnet will keep everything in your pocket.
Golf Tee
If your interior doors have loose hinges, you can simply fix it with a golf tee. Take the door and your hinges off the door’s frame and softly tap your golf tee into every screw hole. Cut the excess, then put the door back on. The tee will provide the screw with something that it can bite into.
Woodworking allows you to create something wonderful with your hands. With these tips in mind, you can start a new project. Apply the ideas and advice presented here in your workshop.